- 4 coil diameter pins which include 2mm, 2.5mm, 3mm, and 3.5mm
- Small allen key
- Small screw
- Cylinder jig
To use the jig:
1.Firstly choose the diameter of the coil and which pin you are going to use.
2.Then put the pin into the end of the jig tube and secure in place with the allen key
3.Put the little screw into the middle of the top cap
4.Then insert your wire into the slanted side whole to hold wire in place.
5.Then put the jig top onto your diameter selected with the centre screw facing the wire and turn using the screw to wind your wire for the desired amount of loops.